Publicité
The exerciser comes pre-assembled. Follow Figures 1-3 to unfold and prepare for use.
• Once unfolded, check that the legs are held securely in place by the locking pin system. Make sure the
pin protrudes through the hole so that the assembly is locked and stable before use. Attach the leg caps
(feet) with the grooved side facing down.
• Place the power adjustment wheel on top of the exerciser.
• After exercising, to fold the exerciser again, push the button in while folding the leg.
INSTRUCTIONS FOR USE:
• The exerciser can be used by resting it on the floor or a table.
• Adjust the resistance using the wheel on the top of the exerciser.
• Do not lean/sit on the exerciser.
• Due to friction during use, the metal legs adjacent to the bottom bracket may be hot; pay attention when
handling.
USING THE COUNTER:
The counter takes a series of automatic measurements when the exercise starts and
displays them on the screen.
Select the different options by pressing the red button repeatedly. An arrow on the
display indicates the selected option.
The displayed value will correspond to the selected option indicated by the arrow.
The available options are listed below:
1. SCAN. The SCAN option makes it possible to display all the options, one after the other, while the exercise
is being carried out. When this option is selected, the arrow in that position will blink, and the information
displayed will change every 4 seconds, cycling through each option.
2. TIME. The TIME option displays the duration of the exercise session. It starts automatically when you
begin exercising and stops after 3 seconds of inactivity.
3. CNT. (COUNT) Shows the number of cycles performed in a session.
4. TOT.CNT (TOTAL COUNTS). Corresponds to the total number of cycles accumulated in several sessions.
5. CAL (CALORIES) Shows the number of calories burned during the session.
• Install the 1.5 V battery respecting the polarity.
• The counter will turn on, showing the STOP indicator in the upper left corner.
• Place the counter on the tab located next to the exerciser's power control wheel.
• Select the option you want to be shown on the screen during the exercise session by pressing the red
button. If you want to view them all in succession, select the SCAN option.
• Start the exercise. The counter will start automatically and the selected option will be displayed on the
screen.
• If you stop exercising, the counter will stop after 4 seconds. The STOP indication will appear in the upper
left corner of the screen.
• If the inactivity is maintained for 4-5 minutes, the counter will switch off completely.
• To reset the values to 0, press and hold the red button for a few seconds.
• (The total number of accumulated cycles will not reset unless the battery is removed.)
• Remove the battery from the counter if you are not going to use it for an extended period of time.
NOTE:
Any serious incident related to the product must be reported to the manufacturer and the
competent authority of the Member State in which the user and/or patient resides.
I3126_Ejerc c_conta_Rev03.indd 5
I3126_Ejerc c_conta_Rev03.indd 5
(ENG)
5
22/08/2023 9:15:12
22/08/2023 9:15:12
Publicité
