Publicité
STORAGE:
when not in use, your appliance is easy to store. allow appliance to cool, then
store out of reach of children in a safe, dry location. Don not jerk or strain cord
at plug connections.
REPLACING (REMOVING) BLADE SET
To remove the FX765C blade set, turn the trimmer to the OFF position and
unplug it from the electrical outlet. Turn the trimmer upside down so that the
teeth of the trimmer are facing down. Place the trimmer on a flat surface and
using the screwdriver, loosen the fastening screws from the blade set. Remove
the blade set from the trimmer (see Fig. 1).
Fig. 1
Blade set
Blade screws
To install or replace your trimmer blade set, reverse the procedure, aligning the
blade cushion shaft into the moving blade bracket (see Fig. 2). With the blade
held in place, replace blade screws and tighten loosely. Turn the trimmer over
and align the blade set parallel to the trimmer's upper housing.
Screws
Guide block
Fig. 2
Screws
FX765C IB-17_126.indd 7-8
Fixed blade
Blade cushion
Moving blade
Blade spring
Screw holes
Be sure that the blades are aligned properly. The teeth of the smaller blade
(cutter) should rest slightly below the upper edge of the larger blade (comb)
approximately 1/64" to 1/32" apart (see Fig. 3). If the blades are not correctly
aligned, they may cut or scratch your skin when trimming. Once the blades
have been aligned, tighten the screws firmly.
Fig. 3
Comb (large blade)
Cutter (small blade)
BLADE CARE
Because the trimmer blades are precision-made for a very special use, they
should always be handled with care. Each time you finish using the trimmer,
take the cleaning brush provided and brush away any loose hair that has
collected in the blades.
Be especially careful when changing or adjusting blades. When you have your
trimmer serviced, be sure that both blades are sharpened or replaced at the
same time.
1/64" – 1/32"
3/31/17 2:32 PM
Publicité
