Publicité
Only use AC adapters intended for this device. Do not apply voltage
other than indicated on the device. This equipment may be used by
children over 8, persons with limited physical and mental capacity
as well as individuals without any experience or unfamiliar with
the equipment, provided that supervision or instruction concerning
safe use of the equipment is provided in a way ensuring the
understanding of potential dangers. Children should not be allowed
to play with the device. Children should not be allowed to perform
cleaning or maintenance of the device unsupervised.
UV LED LAMP 24W/48 SEMILAC
PACKAGE CONTAINS
Semilac UV LED lamp (x1)
Semilac UV LED lamp AC adapter (x1)
Instruction manual (x1)
DESCRIPTION OF PARTS
1. Infrared sensor
2. Digital display
3. 10 s timer button and 24 W/48 mode button
4. 30 s timer button
5. 60 s timer button
6. 90 s timer button (low heat mode)
7. Power supply socket
INSTRUCTION MANUAL
• Please read the manual before use. The intended use of the lamp is curing hybrid, acrylic-gel and UV gel nail products.
• 48 MODE
• Connect the device to its original AC adapter. First connect the power supply cord to the lamp, and only then connect the
AC power supply to a power source.
• Default setting: H30. This mode features a lower power setting and the curing time of 30 seconds. After the device exits
standby mode, you can select the curing time by pressing the buttons: H10S/H30S/H60S/H90S (Low Heat).
• Modes H10S, H30S and H60S activate the motion sensor. When the hand is inserted in the device, the light is automatically
turned on, and then turned off when the hand is taken out. In modes H10S, H30S and H60S, the display counts down the
time.
• Mode H90S is the Low Heat Mode. When this mode is on, the power is increased gradually so as to limit the discomfort
associated with curing gel products. The display shows values between H1 and H90.
• 24 MODE
• Press the 24 W/48 button and hold for 1.5 second – the power of the lamp will increase from 24 W to 48 W.
• Select the desired curing time with the buttons: L10S/L30S/L60S/L90S (Low Heat).
• Modes L10S, L30S and L60S activate the motion sensor. When the hand is inserted in the device, the light is automatically
turned on, and then turned off when the hand is taken out. In modes L10S, L30S and L60S, the display counts down the
time.
• Mode L90S is the Low Heat Mode. When this mode is on, the power is increased gradually so as to limit the discomfort
associated with curing gel products. The display shows values between L1 and L90.
SPECIFICATIONS
36 UV LEDs
Input voltage: 200-240 VAC, 50 Hz/60 Hz
EN 3
Publicité
