Publicité
1. Loosen the 3 nuts (A) that holds the connection
plate (B).
2. Loosen the 5 nuts (C).
3. Remove the blade guard (D) and the connection
plate (B) and disconnect them.
5.3.3 To assemble the cutting unit
•
Assemble in the opposite sequence of
disassemble the cutting unit on page 8 . Tightening
Servicing data on page 5 .
torque: see
5.3.4 To lubricate the gearbox
Instructions of lubricating when replacing the cutting
board.
To make sure product efficiency and lifetime the
recommended grease must be used. The recommended
grease is specified in the IPL and has the article number
580 - 001 - 27.03.2018
A
B
A
A
D
C (×5)
To
503 98 96-03 (20g). The gearbox must not be fully filled
with grease.
•
Apply approximately 2.5 g of grease.
1
3
5.4 Front handle
5.4.1 To remove the front handle
CAUTION: Make sure that the cables to the
handle are not damaged when you assemble
the cover.
5
2
4
Repair instructions - 9
Publicité
