Publicité
4. Push the keypad with holder into the bracket (A)
until you hear a click.
5. Put the flat cable into the grooves in the bracket.
6. Put in the connector (A).
5.10 Main switch and main cable
5.10.1 To disassemble the main switch
1. Remove the control handle.
2. Remove the power trigger lock and power trigger.
To disassemble the power trigger and handle
See
stop on page 11
3. Lift out the main switch and disconnect cable (A).
580 - 001 - 27.03.2018
A
A
A
4. To disconnect the cable, release the catch (D) with a
small screwdriver and pull the connection (C) out.
C
5.10.2 To assemble the main switch
1. Connect cable (A) and make sure that the contact
clicks into place.
2. Assemble the throttle trigger lock and throttle trigger.
3. Assemble the control handle.
5.11 Rear handle
5.11.1 To disassemble the rear handle
WARNING: Make sure the spring does not eject
out and causes injury. Put on protective
goggles.
CAUTION: Do not to damage the cables or the
plugs.
CAUTION: The flat cable to the keypad is very
easily damaged.
D
A
Repair instructions - 17
Publicité
