Publicité
OPERATION
WARNING ! Always use the correct voltage: The voltage of the power
!
source must match with the values on the nameplate of the power tool.
Switching action
To start the sander, push the ON/Off switch downward to position "I".
To switch off the sander, push the On/Off switch I upward to position "O".
WARNING ! Wait until the power tool has come to a complete stop
!
before placing it down.
Sanding Surfaces
Switch the power tool on, place it with the complete sanding surface on the
surface to be worked and move the power tool with moderate pressure over the
workpiece.
The removal capacity and the sanding pattern are mainly determined by the
selection of the sanding sheet, and the applied pressure.
Only flawless sanding sheets achieve good sanding capacity and extend the
service life of the power tool.
Pay attention to apply uniform sanding pressure. Intensifying the sanding
pressure does not increase the sanding performance. It will only cause an
increase in the wear of the tool and sanding sheet.
A sanding sheet that has been used for metal should not be used for other
materials.
Use only original sanding accessories.
19
Publicité
