-
Charge, use and store the product at a
temperature between 50 °F / 10 °C and 95 °F /
35 °C.
-
Keep product and batteries away from fire and do
not expose them to direct sunlight or high
temperatures.
-
If the product becomes abnormally hot or smelly,
changes color or if charging takes longer than
usual, stop using and charging the product and
contact Philips.
-
Do not place products and their batteries in
microwave ovens or on induction cookers.
-
Do not open, modify, pierce, damage or dismantle
the product or battery to prevent batteries from
heating up or releasing toxic or hazardous
substances. Do not short-circuit, overcharge or
reverse charge batteries.
-
If batteries are damaged or leaking, avoid contact
with the skin or eyes. If this occurs, immediately
rinse well with water and seek medical care.
-
When you handle batteries, make sure that your
hands, the product and the batteries are dry.
-
To avoid accidental short-circuiting of batteries
after removal, do not let battery terminals come
into contact with metal objects (e.g. coins,
hairpins, rings). Do not wrap batteries in aluminum
foil. Tape battery terminals or put batteries in a
plastic bag before you discard them.
ISED compliance Canada
-
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
-
This device complies with ISED license-exempt
RSS(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
-
This device complies with the ISED RF exposure
limits and has been evaluated in compliance with
portable exposure condition.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
SAVE THESE INSTRUCTIONS
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that Philips
offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
Note: this Philips OneBlade 360 pack (QP4631)
consists of a OneBlade handle (with model number
QP4530) and a body kit (with model number QP610).
Your product comes with the following components
included:
1 360 blade
2 Blade release switch
3 On/off button
4 Protection cap
5 5-in-1 beard guard
6 Skin guard
7 Body comb
8 Original blade for body
9 USB charging cable
Note: Philips IPX4 (splash-proof) USB power
sources are available for purchase separately.
10 Travel case
This symbol indicates that the product can be used in
the bath or shower.
Getting started
-
This product is only intended for household use.
-
For hygienic reasons, the product should only be
used by one person.
Charging OneBlade
Danger: Keep the USB cable and the USB power
source dry.
Low Battery
When the battery is low, the light ring on the handle
will flash orange (Fig. 2).
Charging with the USB charging cable
1 Insert the small plug into the OneBlade handle,
then insert the USB plug into a USB power source
(not included). Plug the power source into a 120V
AC outlet (Fig. 3).
Tip: the battery contains enough charge for one
shave after 5 minutes of charging.
2 To fully charge the battery, allow it to charge for 1
hour. The light ring flashes white when the
product is charging.
3 The light ring lights up continuously in white when
the product is fully charged (Fig. 4).
4 Unplug the USB power source from the outlet and
then remove the charging cable from the handle.
Note: for safety reasons, the product can only be
used when the charging cable is not attached.
5 A fully charged OneBlade has an operating time of
1 hour.
Turning OneBlade on and off
To turn the product on or off, simply press the power
button once (Fig. 5).
Tip: If the product does not turn on, check that the
battery is fully charged and remove the charging
cable from the handle before pressing the power
button. If the product still does not turn on, check
that the blade is clean and undamaged.
Connecting to the OneBlade app
Download the Philips OneBlade app from the App
Store or Google Play Store to take advantage of your
OneBlade's smart features. The OneBlade app also