Publicité
FILLING WATER
• Take up the kettle from the power base before filling.
• To fill the kettle, open the lid by pressing the lid button
downwards and fill the kettle with as much fresh, cold
water as you desired. The water capacity must be between
the Max and Min level shown on the kettle.
BOILING WATER
• Put the kettle filled with water onto the power base.
• Plug the power base into the mains supply; the kettle
enters the stand-by state and the body shell shows the real
temperature of water.
• To start boiling process, press the button
appliance thereupon enters the boiling process. At this
time, the desired temperature of water can be adjusted
by repeatedly pressing the button
temperature adds all the time. The body shell will show
the chosen degree and the heating indicator light will flash
during adjustment.
• After completing setting for about 5 seconds, a buzzer
makes a voice of "di", the heating indicator light will stop
flashing and be on all the time. Then the body shell shows
the real water temperature and the boiling begins.
• When reaching the adjusted degree, the kettle will
automatically switch off and the buzzer will make a voice of
. Long press it and
19
, the
Publicité
