Publicité
INSTRUCTION MANUAL VOSS.SONIC 1200
After triggering, a short click is audible and the control LED in the upper
half of the motion detector (3) lights up red. The device then emits the
set sound frequency for approx. 30 seconds.
Info
To change a setting, you must always start from the OFF
position (0) and directly select the desired function. For example, if
you change directly from position 5 to 3 without first having turned
back to the OFF position (0), the setting will remain at position 5.
9
MAINTENANCE
The device requires little maintenance. However, you should carry out
regular visual inspections. Check the device for damage before each use.
There are no serviceable parts inside the device.
N OT I C E
Do not use the device if there is any visible damage.
10
CLEANING
N OT I C E
»
Do not use aggressive solvents/cleaning agents, brushes,
sharp objects or similar for cleaning. These can damage
the surface.
»
Do not submerge the device in water or other liquids.
There is a risk of a short circuit.
Clean the device with a damp cloth if it is dirty.
11
TROUBLESHOOTING
N OT I C E
»
Do not make any improper changes or modifications to
the device.
»
Contact Customer Service for repairs.
If the device malfunctions or is found to be otherwise defective, even after
following the suggested solutions below, contact the manufacturer. The
contact details can be found in chapter 15.
Fault/Problem
Pests not
repelled
45018.2 - 08.2024 - V7
Solution
∙
Make sure that the correct settings are being used.
∙
Replace the batteries with new ones (see section 8.1).
∙
Follow the tips for the right location in chapter 7.
DE
EN
FR
IT
NL
SV
ES
21
Publicité
