Publicité
Installation (continued)
11
Making the water supply
connections
NOTE: The hot side inlet tube is indicated by a label.
If the label is not present, the hot supply tube is the longer
of the two inlet tubes.
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
12
Storing the wrench tool
□
After installation is complete, store the wrench (E) and Hex wrench (Hex: 2.5mm, O) provided for use
conveniently next time.
□
Place the slot (1) of the wrench (E) onto the copper tube, then choose the appropriate hole of the wrench (E)
to place the Hex wrench (Hex: 2.5mm, O).
1
E
E
O
11
Please contact 1-855-HD-GLACIER for further assistance.
1
3
E
2
O
HOMEDEPOT.CA
Publicité
