Publicité
5. INSTALLATION
Make sure to install your product so that the sensor is facing a
passageway. Avoid to install it near other light sources.
Soft ground (garden, earth, etc.): Plant the stake (H) in the ground. Then
position the product correctly on it and install/tighten the screws (D).
Make sure that the product is vertical (using a level if necessary).
Hard ground (terrace, etc.): Position the product in the desired location
and mark the holes to be made. Remove the product and drill your
holes. Dust off and insert the anchor studs (C) provided using a hammer
(leave the threaded rod protruding). Remove the nuts and washers,
replace the product and then replace the washers and nuts. Tighten the
nuts firmly using a suitable wrench. Make sure the product is vertical
(using a level if necessary). You can also use screws/dowels suitable for
the structure of your floor. Make sure the fixing is solid.
6. CHARGE
Before charging your device, carefully read the safety instructions
in this manual.
21
Publicité
