Publicité
screw connections. Make sure the covers and guards are undamaged and are installed properly.
5.1. Cleaning.
The easiest way to clean the mower immediately after mowing. After working on the machine
clean thoroughly with a soft brush and cloth. Do not use water and / or solvents and detergents.
Remove all particles of grass, especially from vents. Place the machine on its side and clean the
area of the blade. Always wear protective gloves ! Remove firmly adhering particles of wood or
plastic block.
5.2. Sharpening or replacing the cutting blade.
Replace dull or damaged knives. Knife down and unscrew the main bolt in the center of the
blade spanner 27. Before inserting a new blade or after you have sharpened the old one, make sure
the blade is installed properly. Then tighten the bolt again and make sure that no gaps and the knife
is properly installed. Use only suitable for mower blades.
5.3. Always thoroughly clean the mower when to leave it for longer storage. Especially in the
winter. Brush cutter with oil to protect it from rust. When storing the machine for grass basket must
be removed. To save space, you can disassemble the handle. When disassembling and assembling
the top and bottom of the handle careful not to damage the power cord.
6. Faults and correct them.
The table below shows symptoms of failure and how you can help, if your mower stops working
normally. If you can not find and fix the problem by following the instructions in the table, contact
your authorized service Raider. Attention: Before you start troubleshooting, stop the mower and
disconnect it from the mains.
Faults
Mower does not start
to work
The engine start but the
knife does not rotate.
Engine is turned off
suddenly.
Unusual noise.
Strong vibrations.
Unequal mowing. Engine
work hard and reduce
turnovers.
Removal
Power cable is not connected or damaged
Mower is in a tall grass.
It is possible that the mower is fuzzy and the blade is
blocked.
The power plug is withdrawn
Bolt of the blade is loose or connections between
fasteners.
Distorted and damaged knife.
The grass is very high.
The blade is blunt.
It is possible that the mower is fuzzy and blocked
The blade can be installed incorrectly.
Reasons
Check cable. If necessary, replace it.
Upon initial release always put the
mower in the grass
Disconnect the plug and check it. Put
on your protective gloves and clean the
knife and release
Check cable. Make sure it is well
enshrined in the device (14) and plug
it again.
Fasten the parts.
Immediately stop the mower and replace
the knife in a specialized service.
Increase mowing height.
Replace or tipped knife. See 5.2.
Look underneath the mower and clean
it. Work always with protective gloves.
Check. See 5.2
15
Publicité
