Publicité
HSM Mode
Power ON/OFF
Reset control pad
Protection and Alarm
Anti-interference: message/alarm „E02" appears when the desktop vibrates, is interfered
with, or tilts during an adjustment. Stop adjustment immediately and reverse movement;
after a certain adjustment the alarm will disappear.
Overheating protection: message/alarm „Hot" appears when continuous adjustment time
exceeds 2 minutes, the overheating protection will be triggered. Stop adjustment immedia-
tely; wait for 18 minutes after which the alarm will disappear.
Motor malfunction protection: message/alarm „E10" appears. Power should be disconnec-
ted, recheck and ensure that the motor connected to the controller is secure, connect to
power source.
Over load protection: message/alarm „E20" appears when the table is raised while over loa-
ded. Remove weight, heavy objects from the table before adjustments. If over load occurs
when lowering the table, please press the
Out of Sync protection: message/alarm „E60" appears (multi-motor systems only!). Power
should be disconnected, recheck and ensure that the motor connected to the controller is
secure, connect to power source for reset.
When the light is flashing, the table will slowly move up 12 cm in 3 minutes,
will stop for 2 minutes, and then will slowly move down by 12 cm in 3 minu-
tes. After 2 minutes the movements will repeat.
1. Press the key
to turn the operating system ON; the backlight light
will be on.
2. The system automatically shuts OFF after 4 hours.
* If operating other keys, the backlight is off.
In the lowest position or when prompted by the „protection and alarm"
message, press the down arrow for 3+ seconds, the table moves all the way
down and will raise to a preset height at which time the reset is completed.
Notice: Objects under the table should be removed before the reset opera-
tion to prevent damage to table or other items
for 3+ seconds to reset.
26
GB
Publicité
