Publicité
Installation (continued)
3
Making the electrical connections
NOTE: Always use wire nuts (AA) (included) to connect
wires and push all excess wires and connections back into
the outlet box (not ncluded).
NOTE: When installing the lamp body (A), the direction of
the drainage hole needs to be down.
Connect the ground wire (green wire or bare copper wire) from
the branch circuit to the green ground screw (EE) on the
mounting plate (BB) and then connect it to the ground wire
from the fixture.
EE
Connect the fixture wires as follows:
WHITE WIRE
FROM FIXTURE
BLACK WIRE
FROM FIXTURE
GROUND WIRE
FROM FIXTURE
Install the lamp body (A) to the mounting plate (BB)
the
washers (HH) and
mounting screws (DD).
BB
AA
Drainage hole
WHITE WIRE
FROM HOUSE
BLACK WIRE
FROM HOUSE
GROUND WIRE
FROM HOUSE
secure with
4
Installing the glass shade
NOTE: When installing the glass shade (B), the direction of
the drainage hole needs to be down.
Apply the silicone gel (not included) around the
lamp body (A) where it comes into contact with the wall.
Install the
glass shade (B) to the
with set screw (II).
Silicone gel
DD
HH
A
Drainage hole
6
lamp body (A) and secure
A
II
B
Publicité
