Publicité
3 Charging Status LED Indicator
4 Battery Charger Selection (Reference only)
◆
12 Volt Battery
MZ Model
MZ_OP_1218
MZ_OP_1225
The above suggested battery charger selection is based on battery capacity multiply 0.2~0.3. Example: 100Ah battery *
0.2 / 0.3 = 20A~30A in this case please select MZBC_1225.
5. Installing the Ocean Battery Charger
(See the electrical connection at the end of the manual).
When selecting the installation location, observe the following instructions:
➢
The battery charger can be installed horizontally or vertically.
➢
Do not install the charger in following situations:
◼
In wet environment
◼
In dusty environment
◼
In the vicinity of combustible materials
◼
In areas where there is a danger of explosions
➢
The place of installation must be well ventilated. A ventilation system must be available for installation
in small, enclosed space. The clearance around the device must be at least 25cm.
➢
The charger must be installed on a level and sufficiently sturdy surface.
➢
Do not install the charger above batteries, because they can emit corrosive sulphur fumes that will
damage the device.
➢
For ambient temperatures higher than 40 ℃ (such as in engine or heating compartments, or direct
sunlight), the heat from the charger under load can lead to reduced output.
➢
The air inlet on the underside and the air outlet on the back of charger must remain clear.
Charging status
GREEN led
Bulk
GREEN led
Absorption
YELLOW led
GREEN led
Float
YELLOW led
GREEN led
No Battery
RED led
Battery capacity range
50~80Ah
80~125Ah
LED Status
Estimated charging time
6~24
6~24
4
English
Rev.04-2022
Publicité
