Publicité
Towel Warmer Installation Procedure
2
Installation Instructions
1. Check all items have been received. You should have Towel Warmer and mounting bracket kit. Read all instructions
before continuing.
2. Fix wall supports "B" including collar "A" to the wall using the screws provided and in locations as shown on figure 2.
3. Screw the threaded pin "C", into the threaded bushing "D".
4. Hang and adjust the Towel Warmer using set screws "E" to lock pin "C" in the wall bracket "B". Ensure the Towel
Warmer is firmly and safely fixed.
fig. 3
3
Valve Connection
1. If using a hydronic installation pack, slide escutcheon (supplied with hydronic installation pack) over 1/2" supply pipe.
2. Unscrew male threaded components including collars from valve and thread into female inlets at bottom of towel
warmer using a 12mm allen key wrench.
3. Push compression fitting on to 1/2" supply pipe and tighten 1/2" compression fitting collar on valve.
4. Seat male threaded component (now connected to towel warmer) on valve and tighten collar.
5. Insert blank plug and air vent plug (supplied with bracket kit) into top female inlets on towel warmer.
6. Check for leaks and bleed system if necessary using air vent plug.
Warning: All hydronic plumbing connections should be made in accordance with local and
national plumbing regulations. It is the responsibility of the plumber to ensure plumbing
system and towel warmer installation comply with these regulations.
(see figure 3)
(see figure 5, 6, 8 or 9)
5
Publicité
