Publicité
E
3. Handlebar installation
First, align the face of the handlebar side with the steering main shaft hole, pass the
M5*40 bolt through the hole and then tighten the nut to fix it, insert the steering spindle
into the body shaft hole and pass through the connecting plate, and finally insert the
gasket under the spindle and tighten it with M8 nut.
4.Power cable layout
First remove the screws on the seat with a Phillips screwdriver, then insert the two wiring
plugs in the battery compartment to match, and finally put the seat into the body and lock
it with screws.
5. Tails tock mounting
Handlebar and backrest assembly
Align the tail frame holes and place them in the rear
screw stud of the body, then use
screws to lock and secure.
12
13
4*12 self-tapping
Ø
6
Publicité
