Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LCD monitor buttons advanced function
Press
for more than 5 seconds and you will enter „advanced mode".
Button
= ESC (back to main screen)
1 SET UNIT
Set up tire pressure ( PSI / BAR /KPA / KgCM² ) and
temperature ( C / F ) measuring unit.
Button
= NEXT (into the next mode)
Button
= ADJ (adjustment)
Button
= ENTER (choose this confi guration)
2 SET THRESHOLD
(Before: Choose a car type --> „3 SET CAR TYPE")
A. Setting low pressure – SET LO.P (Low Pressure)
B. Setting high pressure – SET HI.P (High Pressure)
C. Setting the high temperature – SET HI.T (High Temperature)
Press button
into the next mode.
Press button
to decrease the setting fi gure.
Press button
to increase the setting fi gure.
D. Fast setting
The fast setting will confi gure all tire pressure and temperature in same level. You just need to press
more than 3 seconds and all tires will be blinking and followed by same procedure as previous content
3 SET CAR TYPE
Choose a car type.
Button
= NEXT (next car type)
Button
= ENTER (choose this confi guration)
4 SET SENSOR ID
Normally, original sensor has its own identifi ed number and you won't need to do anything with sensors.
However, whenever you lost your original sensor or sensor is broken, you will need to purchase a new „learn-
able sensor" to replace. The 'learnable' sensor can be bought in your local dealer.
Button
= ESC (back)
Tire pressure sensor installation
1. Install the battery. Attention: the negative pole must face the open end of the sensor.
Don't mix up the batteries caps!
2. Install the disassembly prevention lock to the tire valve stem.
(–> „Anti theft installation guide").
–
+
English
for
+
–
15
Publicité
Table des Matières
