Publicité
4. The sensor will be more sensitive to motion across its detection
path than motion directly towards it. (See Fig.
5. To reduce possible nuisances, do not mount the fixture near a heat
source like an air conditioner, vent or furnace exhaust, or in a
direction facing any reflective object or other nearby light source.
Troubleshooting
---The light does not work.
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
3. Cover the sensor with dark color cloth to verify that the ambient light level is not too high.
---The light comes on for no apparent reason:
1. Re-aim the motion sensor.
2. Decrease the sensitivity setting.
3. Do not use a dimmer or timer to control the light fixture. Replace the dimmer or timer with a standard on/off wall switch.
---The light flashes on and off:
1. Reposition the light head away from the motion sensor.
2. Reposition the motion sensor.
3. The motion sensor is in "TEST" mode and warm up.
The following parts are available for re-order if damaged or missing.
Mounting Screw X2
Mounting Screw X2
#8/32X1/2 in
#6/32 X1/2 in
A
Vaxcel warrants all of our products against defects in workmanship and finishes for one year following the date of shipment.
In addition:
● Any product with an integrated motion sensor or dusk-to-dawn photocell is supported by a 5-year warranty for the
functionality of the product.
● Any product with integrated LED modules is covered by a 5-year warranty on the LED functionality.
Exclusions: This warranty does not include the failure of products from extreme acts of nature; environmental conditions
not suited for the products intended use; operation in temperatures outside of the range specified in the instruction manual;
usage with improper power supply, power surges or dips. For coastal locations, some corrosion is considered normal for
the environment.
Vaxcel reserves the right to repair, replace or issue a credit for any properly installed product, provided it is returned per
RMA instruction. This warranty is limited to the cost of the product only and does not extend to transportation, installation
or replacement costs.
)
Mounting Screw X2
Mounting Strap
#10/24 X1/4 in
B
5 Year Limited Warranty
How can warranty service be obtained?
info@vaxcel.com
1-800-482-9235
Page 5 / 5
Fig.
Motion
Least sensitive
Fixture Mounting Screw
Assembly Kit
6613MM (1 SET) FOR T0700
6614MM (1 SET) FOR T0701
C
Sensor
Most sensitive
Wire Connector
Decorative cover
A: 6-3/4"
B: 10-3/4"
C: 5-3/4"
241119
Motion
Gasket
Publicité
