Publicité
Sensitivity of Motion Sensor
of the bottom surface of the sensor. (See Fig. 4)
Adjusting the Light Head:
1. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the light
heads at least 1" (25mm) away from the sensor.(See Fig. 5)
2.
Fig. 4
Functions and Operations
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.4)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. TEST MODE (daytime and nighttime operation.)
continues. Then it reverts back to low-level
5 seconds after motion is no longer detected.
Note: You can adjust the CCT color (2700K~5000K) by using the CCT color (2700K~5000K) knob on
the backplate (See Fig.6)
2. OFF MODE (nighttime operation only)
the light turns to high-level brightness (5000K) when motion is detected, and stays on as long as motion continues.
When the motion is no longer detected, it remains on for the predetermined shut-off delay time you set
(30s/1min/3min), and then turns off automatically.
3. AUTO MODE (nighttime operation only)
(30s/1min/3min). At dusk, the light turns on to low-level
and pre-selected CCT color (2700K ~ 5000K). When motion is detected,
the light turns to full brightness (5000K) and stays on as long as motion
continues. When the motion is no longer detected, the light at full
brightness (5000K), remains on for predetermined time you set
(30s/1min/3min), and then switch back to the set CCT color automatically.
Note: You can adjust the CCT color (2700K~5000K) by using the CCT color (2700K~5000K) knob on
the backplate (See Fig.6)
4. PC MODE (nighttime operation only)
Note: You can adjust the CCT color (2700K~5000K) by using the CCT color (2700K ~5000K) knob on the
backplate. (See Fig.6)
MODE
Off
Auto
TIME
SENS
M
PC
30s
1min
L
H
Test
3min
3H
Custom Setting
Fig. 5
30% brightness and pre-selected CCT color (2700K ~ 5000K) about
30% brightness
Page 3 / 5
Light Head
Fig.6
241119
Publicité
