Publicité
Fig. 2
Sensitivity of Motion Sensor
side of the bottom surface of the sensor. (See Fig. 4)
Adjusting the Light Head:
1. Gently grasp the light heads and tilt them left or right to adjust the light coverage area. Keep the light heads at
least 1" (25mm) away from the sensor.(See Fig. 5)
Please adjust the light heads while they are in room temperature.
2.
Fig. 4
30s
1min
Test
3min
Functions and Operations
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.4)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
continues. Then it reverts back to low-level
2.
the light turns to high-level brightness when motion is detected, and stays on as long as motion continues.
When the motion is no longer detected, it remains on for the predetermined shut-off delay time you set
(30s/1min/3min), and then turns off automatically.
to low-level
30% brightness. When motion is detected, the light turns to high-level brightness and stays on as
long as motion continues. When the motion is no longer detected, the light at high-level brightness
remains on for the predetermined time you set (30s/1min/3min), then switches back to low-level
brightness automatically.
OFF
AUTO
M
PC
L
H
3H
Custom Setting
30% brightness about 5 seconds after motion is no longer detected.
Page 3 / 5
Fig. 3
Sensor Adjustment Lower For Short Coverage
Fig. 5
Light Head
30%
241114
Publicité
