Publicité
6. Manual Override (nighttime operation only)
or "3H" mode for on-demand continuous high-level
brightness at night, turn the wall switch off then turn it
on twice within 3 seconds, the light remains on all night long.
To shift back to "OFF" or "AUTO" or "3H" mode, turn the wall
switch off then turn it on twice within 3 seconds again.
(See Fig.6)
Note: To make sure the above functions operate properly,
always keep the wall switch in the ON position (including
the daytime).
Customization Options:
Shut-off Delay
brightness after motion is detected.
arrow so it points to the desired time setting (30s/1min/3min).
To increase the shut-off delay, turn the knob clockwise.
To decrease the shut-off delay, turn the knob counterclockwise.
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
ensure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above the
ground. At such a height, the fixture will provide a detection
3. The sensor detects movement across a detection range of 180 degrees. (See Fig.8)
4. The sensor will be more sensitive to motion across its detection path than motion directly towards it. (See Fig.9)
5. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflective object or other nearby light source.
Troubleshooting
---The light does not work:
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
3. Cover the sensor with dark color cloth to verify that the ambient light level is not too high.
---The light comes on for no apparent reason:
1. Re-aim the motion sensor.
2. Decrease the sensitivity setting.
3. Do not use a dimmer or timer to control the light fixture. Replace the dimmer or timer with a standard on/off wall
switch.
---The light flashes on and off:
1. Reposition the light head away from the motion sensor.
2. Reposition the motion sensor.
3. The motion sensor is in "TEST" mode and warm up.
"OFF" or "AUTO"
Page 4 / 5
Fig.6
Turn wall switch OFF-ON-OFF-ON
in 0.5~3 Seconds
"AUTO" "OFF"
or "3H" Mode
Turn wall switch OFF-ON-OFF-ON
in 0.5~3 Seconds
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
or eave; otherwise, the detection distance may
be limited.
12.0'
8.0'
10'
Fig.9
Motion
Sensor
Least sensitive
Manual
Override
Fig.8
Motion
Most sensitive
241119
Publicité
