Publicité
Sensitivity of Motion Sensor
of the bottom surface of the sensor. (See Fig. 4)
Adjusting the Light Head:
1. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the light
heads at least 1" (25mm) away from the sensor.(See Fig. 5)
2.
Fig. 4
Functions and Operations
Choose a mode by sliding the switch on the bottom of the sensor of the fixture. (See Fig.4)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. TEST MODE (daytime and nighttime operation.)
2. OFF MODE (nighttime operation only)
the light turns to high-level brightness (5000K) when motion is detected, and stays on as long as motion continues.
When the motion is no longer detected, it remains on for the predetermined shut-off delay time you set
(30s/1min/3min), and then turns off automatically.
3. AUTO MODE (nighttime operation only)
stays on as long as motion continues. When the motion is no longer detected, the light at high-level brightness
(5000K) remains on for the predetermined time you set (30s/1min/3min), then switches back to low-level
4. PC MODE (nighttime operation only)
5. 3 HOURS (3H) MODE (nighttime operation only)
long as motion continues. When motion is no longer detected, it remains on for the predetermined shut-off delay
This side down
SENS
TIME
3min
Test
1min
30s
MODE
Page 3 / 5
Fig. 5
Light Head
30%
241119
Publicité
