Publicité
4. This scale is intended for home/consumer use only. It is not intended for commercial
or medical use.
5. This scale is designed to read weights up to 33 lb x 0.1 oz / 530 oz x 0.1 oz / 15 kg x 2 g
/ 15000 g x 2 g. To prevent damage, do not place more than 33 lb / 530 oz/ 15 kg /
15000g on the scale.
6. "O-Ld" = Overload Warning: Should "O-Ld" appear on the display during a weighing,
this indicates that the maximum weighing capacity has been exceeded. Remove the
weight immediately otherwise permanent damage could occur.
7. Do not store scale where you store cleaning chemicals. The vapors from some
household products may affect the electronic components of your scale. Do not store
scale on its side.
8. This scale is an extremely sensitive weighing device. In order to prevent run down of
the battery, do not store anything on the scale.
9. Do not dispose of batteries in fire. Batteries may explode or leak. Remove the
batteries if the scale will not be used for a long period of time.
10. "Err" = Instability Error. Should "Err" appear on the display, this indicates the scale is
unstable. Place the scale on a hard, level surface during use.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Publicité
