Important Safety Instructions - Schwaiger LED220 011 Instructions De Service

USER MANUAL LED220 011
WARNING:
LEDs can be damaged by electro static discharge (ESD) shock. Befo-
re installation, discharge yourself by touching a grounded bare metal
surface to remove this hazard. To avoid damage, do not remove the
clear lens over the LED module.

IMPORTANT SAFETY INSTRUCTIONS

1. Do NOT touch LEDs.
2. Do NOT remove the protective clear LED lens.
3. Do NOT look directly at lighted LEDs for any length of time.
4. Electrical requirements: 4.5 V DC, 3x 1.5 V LR14 (C)
5. Fixture can only be wall mounted. NOT suitable for ground mount
or eave mount installations.
Select the installation location carefully. Do not install in areas having
pedestrian or motorized traffi c, pools or bodies of water, or trees/bus-
hes that move in the wind. All of these may trigger the motion sensor
led lamp and may be disruptive to the intended operation of the light.
TO BEGIN:
WARNING:
Review important safety instructions before installation. Check to
make sure you have the following:
Rear housing cover Rear housing cover
Hardware Kit (Actual hardware may differ from illustration.) Hardware Kit (Actual hardware may differ from illustration.)
6
ITEMS REQUIRED
Installation Time: 45 Minutes.
Screwdriver
Safety Glasses
Drill
FIXTURE INSTALLATION
1
Light head Light head
Remove the rear housing cover by turning counter-clockwise until it
comes loose (Fig. 1)
Low battery Low battery
For mounting to concrete or masonry, install the anchors, by drilling
indicator indicator
two 3/16-in. pilot holes into the mounting surface. Insert the anchors
into the holes and tap them into place so they are fl ush with the surfa-
ce (Fig. 2). Place the rear housing cover, with the writing facing away
from the wall, over the mounting location and secure the rear housing
cover to the mounting surface with wood screws (Fig. 3).
PIR Sensor PIR Sensor
Step Ladder
Soft Cloth
3/16" Drill bit
2
3