Publicité
Air Conditioner Remote Control
The functions work the same as your air conditioner's
touch controls.
CAUTION:
• Use only AAA or IEC R03 1.5V batteries.
• Remove the batteries if the remote controller is not used for a
month or longer.
• Do not attempt to recharge the supplied batteries
• All batteries should be replaced at the same time.
• Do not dispose of the batteries in a fire as they may explode.
• Do not mix old and new batteries.
• Do not install the batteries with the polarity (+/–) reversed.
• Keep batteries and other objects that could be swallowed
away from young children. Contact a doctor immediately if an
object is swallowed.
Caution:
If air conditioner is shut off,
wait a minimum of three
minutes before restarting.
A
C
A
C
B
Filter
Louvers
Air Circulation Without Cooling or Heating
1.Close vent door.
2. Turn Master Control to HI FAN.
Exhaust Operation Without Cooling or Heating
1.Open vent door.
2. Turn Master Control to HI FAN.
Directing Airflow
Unit is engineered with adjustable louvers to direct discharge airflow. Louvers are
manually adjusted by moving levers in direction of desired airflow.
B
Cleaning the Air Filter
1. Turn Master Control to OFF.
2. Remove the air filter by opening the air intake panel on the decorative front and
pull it out of the unit.
3. Wash in hot soapy water, rinse and shake dry.
4. Replace the filter, with the front of the filter toward you.
5. To dry the filter thoroughly, run your unit for a few minutes. Remember, only a
clean filter works properly and delivers top efficiency at every setting.
Vent door
Note: Failure to keep air filter clean will result in poor air circulation.
DO NOT operate without filter. This can render the unit inoperative.
Proper use and care of your air conditioner will help ensure longer life of the
unit. It is recommended to annually inspect and clean the coils and condensate
water passages. Expense of annual inspection is the consumer's responsibility.
Clean the filter every two weeks
7
OPERATION
REMOTE / AIR FILTER
Remove the back cover
and insert the batteries
with the poles (+) and (-)
in the correct position.
AAA
IEC R03
1.5V
Publicité
