Publicité
•
Regularly clean air holes and loudspeakers of the projector with the use
of a soft brush, otherwise ventilation may get blocked. Clean the dust
filter on a regular basis.
•
Clean the slot under the dust cover (2, fig. 2) on a regular basis to maintain
good picture quality.
High temperature
•
When the project is on, make sure the air holes of the device are not
covered. For this reason do not place it on soft surfaces or cover with
materials.
•
Do not look into the lens when it is operating.
Additional information
•
Do not place any liquids or heavy items on the projector.
•
Do not disassemble the projector on your own – electric shock risk.
To assure stable dissipation of heat, before you start the projector, adjust its
height in the lower part with the use of a base adjustment knob.
The product complies with requirements of EU directives.
Pursuant to the Directive 2012/19/EU, this product is subject to selective
collection. The product must not be disposed of along with domestic waste
as it may pose a threat to the environment and human health. Worn-out
product must be handed over to the electrics and electronics recycling center.
Description of projector parts (fig. 1)
1. Base adjustment knob
2. Infrared receiver
3. Lens
4. Power cord port
5. Wireless network port
6. Rear infrared receiver
7. Audio output 3.5 mm
8. HDMI 1 port
9. USB ports
10. AV input
11. HDMI 2 port
12. Loudspeaker
13. Fan
14. Dust filter cover
15. Dust filter
EN
Publicité
