Publicité
®
WPLED 52W/ 80W INSTALLATION INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
WIRING
Universal voltage driver permits operation at 120V to 277VAC,
50 or 60 Hz except fixtures factory ordered with a 120V swivel
photocell (/PCS) or 277V swivel photocell (/PCS2). Units
ordered with (/347V) suffix are 347V.
1. Connect the BLACK fixture lead to the (+) LINE supply lead.
2. Connect the WHITE fixture lead to the (-) COMMON supply
lead.
3. Connect the bare copper Ground wire from fixture to
supply ground.
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru 277V,
50 or 60 Hz. For 0-10V Dimming, follow the wiring directions
as in fig. 2.
1. Connect the black fixture lead to the (+) LINE supply lead.
2. Connect the white fixture lead to the (-) COMMON supply
lead.
3. Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the gray fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.
Patents: US: pat. D653,377
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
installation, operation or maintenance.
Easy Installation & Product Help
Tech Help Line
©2015 RC LIGHTING, LLC
Call our experts 888 722-1000
Northvale, New Jersey 07647 USA
WPLED52 80 RCL IN 0115
PHOTOCELL INSTALLATION
Photocell may be installed in the field. Apply weatherproof
silicone sealant to all plugs and unused conduit entries.
1. Remove close up plug on top of the wall mounting box.
2. Install photocell and wire as per diagram.
3. Use photocell rated for your supply voltage.
PHOTOCELL
Fig. 1
PHOTOCELL
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Is the fixture grounded properly?
3. Be sure the photocell, if used, is functioning properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean glass lens with non-abrasive glass cleaning
Fig. 2
solution.
2. Do not open the fixture to clean the LED. Do not touch
the LED.
rclighting.ca
Visit our website for product info
BLACK
"COM"
WHITE
email
Answered promptly sales@rclighting.ca
LIGHT
WP2FC
FIXTURE
Publicité
