cleaning solvents. COMPLETELY air dry the filters before reassembling. Do not use hair
dryer to dry the filter. This may cause the filter to warp.
Cleaning the roller brush:
After a long period of using, the bristle may be jammed by hair or something similar, it
is required to clean it on time in order to make the appliance to work efficiently.
1. Remove the motorized power brush from the main unit before cleaning the roller
brush.
2. Turn the lock to unlock mark. Open the roller cover, take out the roller from the
brush.
3. Carefully clean and remove the hairs and debris from the brush roller. Wipe to clean
only, do not use any soap or harsh cleaning solvents.
4. After cleaning, reassemble the roller into the brush and turn the lock to the lock mark
5. If roller brush becomes damp, allow to dry naturally before replacing.
TROUBLESHOOTING
PROBLEM
Appliance is
not power on
Vacuum is
stopped sud-
denly
Suction of the
vacuum is
reduced
Motorized
power brush
is not rotating
22
POSSIBLE CAUSES
This can occur if the applian-
ce has been used or stored
for an extended period of
time
This will occur if the safety
cut-out device has been
activated. This device is
designed to prevent your
appliance from overheating
This is probably caused by
dust blockages
This tends to occur when
there are too many fibers
wrapped around the brush
roll restricting movement
SOLUTION
Connect the vacuum to the charger
and allow for a full charging cycle to
complete
Ensure the vacuum is turned off,
disconnect all accessories and leave
to cool down for at least half an hour
before attempting to operate again.
Try to identify the source of the over-
heat by checking for blockages in the
extension tube motor-drive floor head
and accessories. Empty the dust con-
tainer and clean or replace the filter
Turn the vacuum off. Disconnect the
floor head, extension tube and any
accessories. Check for and remove
any blockages from the dustbin filter,
air duct, extension tube floor head
and accessories
Check the maintenance section of
this manual for instructions on how
to appropriately clean the brush roll