Publicité
INSTRUCTIONS OF USE
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply
in your area matches that on the rating label of the unit.
• Fan only mode: Rotate the Power knob to the « » position.
• Low Heat mode: Rotate the power knob to the « » position.
• High Heat mode: Rotate the power knob to the « » position.
• When using the power mode, once you have set the mode, turn the thermostat knob
fully clockwise to start it. The indicator lights will be on once the heater starts working.
• In Heat mode, once your desired temperature is reached, slowly turn the thermostat
knob anticlockwise again until you hear a click. The heater will then stop working, and it
will turn on and off automatically to maintain the set room temperature.
• To switch off the heater, turn the thermostat knob to the minimum position, then turn
the power knob to the "0" position.
NOTE: To assist in maintaining the internal components, after a long-time of heating, it is
suggested to activate Fan only mode to blow room air for a period of 15 seconds before
shutting down.
Model identifier(s): ALPHA CERAMIC
Item
Heat output
Nominal heat output
Minimum heat output
(indicative)
Maximum continuous
heat output
Auxiliary electricity consumption
At nominal heat output
At minimum heat output
In standby mode
18
Symbol
Value
Pnom
2,0
Pmin
1,4
Pmax, c
2,0
ELmax
0,000
ELmin
0,000
ELsb
0,000
Unit
Item
Type of heat input, for electric
storage local space heaters only
(select one)
kW
Manual heat charge
control, with integrated
thermostat
kW
Manual heat charge
control with room and/
or outdoor temperature
feedback
kW
Electronic heat charge
control with room and/
or outdoor temperature
feedback
fan assisted heat output
kW
Type of heat output/room tempe-
rature control (select one)
kW
Single stage heat output
and no room temperatu-
re control
kW
Two or more manual
stages, no room tempe-
rature control
Unit
n/a
n/a
n/a
n/a
no
no
Publicité
