Manuels Connexes pour CDL HOBBY PRO
Sommaire des Matières pour CDL HOBBY PRO
- Page 1 OWNER’S MANUAL Version 1.3 | 22/12/2021 670090200SS-MAN HOBBY PRO EVAPORATOR Hobby Pro evaporator shown with the optional 3-way pan (670090214) © All rights reserved - CDL Sugaring Equipment...
- Page 2 Thank you for choosing a CDL wood evaporator. Our 40 years of experience serving maple syrup producers means that you’ve purchased a high-quality, powerful piece of equipment. INFORMATION Record these details for future reference Brand: ________________________________________________ Date purchased: ________________________________________ Model number: _________________________________________...
- Page 3 TABLE OF CONTENTS BASIC COMPONENTS INCLUDED OPTIONAL PARTS ASSEMBLY AND INSTALLATION CUTTING INSULATION FOR THE DOOR AND FRONT AND BACK PLATES BRICKING OPERATING THE EVAPORATOR WARRANTY SAFETY Wood evaporators can be dangerous. Always wear heat-proof gloves and clothing when operating an evaporator.
- Page 4 BASIC COMPONENTS INCLUDED • Panels and door for assembling • Nuts and bolts • Handle • Ceramic wool (23" x 48") • Black steel 90° elbow • 2 6" pipes, black steel OPTIONAL PARTS NUMBER DESCRIPTION NUMBER DESCRIPTION 19 FIRE BRICKS 670090213 WHEEL KIT 670090217...
- Page 5 ASSEMBLY AND INSTALLATION Please make sure to follow the steps below to ensure proper operation of the evaporator. Part number Description Description EVHO-A00024 FRONT PANEL ASSEMBLY SS EVHO-A00021 HOBBY EVAPORATOR DOOR ASSEMBLY EVHO-P00047 SIDE PLATE SS EVHO-P00048 LOWER SIDE PLATE SS EVHO-P00049 BOTTOM PLATE SS EVHO-P00050...
- Page 6 COMPONENTS...
- Page 7 STEP 1...
- Page 8 STEP 2...
- Page 9 STEP 3...
- Page 10 CUTTING INSULATION FOR THE DOOR AND FRONT AND BACK PLATES Use scissors or a utility knife to cut each piece. Refer to the cutting diagram below. Measure and cut along the dotted lines. 1. Cut 2 pieces of insulation for the front and rear panels (P1 and P2), as shown in the diagram below.
- Page 11 You can order bricks as an add-on to your order or go to your nearest CDL distributor. Refer to step 5 on page 13 for instructions on bricking. Once the arch has been bricked, use the rest of the wool to insulate the sides that aren’t covered by the bricks.
- Page 12 STEP 4 Door assembly...
- Page 13 STEP 5 Bricking...
- Page 14 IMPORTANT SAFETY NOTE THE AREA IN FRONT OF THE EVAPORATOR DOOR IS VERY HOT WHEN THE DOOR IS OPEN. ALWAYS WEAR HEAT-RESISTANT GLOVES, PROTECTIVE CLOTHING AND SAFETY GOGGLES. INSUFFICIENT PROTECTION MAY LEAD TO SEVERE BURNS. OPERATING THE EVAPORATOR Before turning the evaporator on: •...
- Page 15 Your evaporator is covered by a two year limited warranty. For two years from your original date of purchase, Les Équipements d’Érablière CDL (CDL), will replace or replace any parts of this evaporator that prove to be defective in materials or workmanship when such evaporator is installed, used and maintained in accordance with the provided instructions.
- Page 16 CDL shall not be liable for consequential or incidental damages such as property damages and incidental expenses or loss or revenues caused by any event covered by this warranty.