Publicité
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Do not use the chuck with SDS connector in combination with the
hammer/hammer drill function!
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Rated Voltage
Rated Frequency
Rated Power
Rotation speed
Protection class
Drill capacity concrete
Drill capacity steel
Drill capacity wood
Impact rate
Cable length
Chuck type
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION!
over 85 dB(A).
aw (Vibration)
Copyright © 2024 VARO NV
POWX1175
97 dB(A)
108 dB(A)
Wear
hearing
14.6 m/s²
P a g e
220-240 V
50 Hz
1600 W
-1
800 min
II
32 mm
13 mm
40 mm
-1
3900 min
3 m + VDE plug
13mm chuck and adapter
protection
when
| 7
sound
pressure
K = 1,5 m/s²
www.varo.com
EN
is
Publicité
