Publicité
STEP 4: When the countdown reaches
START
zero, "START" will flash on the screen
and three lines will display. Blow
firmly through the mouthpiece for five
BAC
seconds while the unit emits a long
beeping sound. Stop blowing as soon
as the beeping sound stops.
The BACtrack Breathalyzer will turn off automatically in
BAC
15-20 seconds. You can also turn off the breathalyzer during
the countdown by pressing and holding down (start button
Error Notification
symbol) for 3 seconds.
If a user does not blow a sufficient breath sample, the LCD
START
START
START
will display "FLo". Press start to restart the countdown cycle
and retest. Please ensure that you are blowing firmly into the
BAC
device for the entire five seconds.
BAC
BAC
BAC
STEP 5: Once the sensor has
analyzed the breath sample, the
BAC
estimated BAC value is displayed.
BAC
BAC
BAC
Error Notification
Error Notification
Error Notification
BAC
If a user does not blow a sufficient
breath sample, the LCD will display
"FLo". Press start to restart the
BAC
countdown cycle and retest.
BAC
BAC
BAC
EN-8
BAC
BAC
BAC
BAC
BAC
BAC
BAC
If there is no breath sample blown
within 15 seconds, the LCD will
display "Out". Press start to restart
the countdown cycle and retest.
BAC
BAC
BAC
If the unit is powered on outside of the
acceptable temperature range (0-40 °C
or 32-104 °F) the unit will display Out°F
and testing cannot be performed.
BAC
BAC
BAC
If the battery indicator display is
empty, install two new alkaline AAA
batteries.
BAC
BAC
BAC
If the unit displays "Err2" after step 4,
it means excessive salvia went into
the sensor during the test. Wait 20
BAC
BAC
BAC
minutes, and then try again.
Memory Mode
Enter the memory mode by pressing the memory button
during the countdown. The most recent test result
will occur first. The next test results will be displayed
sequentially by pressing the memory button. The
breathalyzer will recall up to 10 tests. If the memory is
full, the oldest test will be deleted automatically.
EN-9
Publicité
