Publicité
9
Depending on the specific size & weight of the plasma, articulating swing arm may be angled at different positions,
causing plasma to appear to lean sideways at different articulating positions. Tilt-roll assembly (B) allows plasma to
be manually adjusted, so plasma can be horizontal at all positions. To adjust, gently rotate plasma by hand to desired
position.
9-1
If it is too difficult to adjust roll of plasma, loosen screws shown in figure 9.1 using a phillips screwdriver.
IMPORTANT! Do not loosen or tighten screws more than 1/8 turn.
ARTICULATING ARM
13 of 39
PLASMA
ROLL
ADJUSTMENT
SCREWS
fig 9.1
ISSUED: 11-20-06 SHEET #: 202-9178-2 12-07-06
All other brand and product names are trademarks or registered trademarks of their respective owners.
©2006 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
Publicité
