Publicité
PRODUCT DESCRIPTION
1. Blender jar
2. Blade
3. Blade assembly
4. Base
.
5. Grinder jar
6. Grinder blade
e
7. Grinder blade assembly
8. Lid with the opening system
9. Lid
10. Display
11. Base
s
OPERATING INSTRUCTIONS
e
NOTICE
y
Before putting a new appliance into operation, you should wipe it thoroughly from the outside with a damp cloth and
wash all removable parts in warm water for hygienic reasons.
The appliance has a built-in safety fuse. The appliance motor can only be switched on if the accessories are properly
fitted. Do not bypass the safety mechanism!
Never leave the appliance unattended while in operation or switched off, but plugged in!
Immediately after switching off the motor and unplugging the power cord, some parts may be still moving
for a while. Wait until the accessory has completely stopped before opening the lid.
CONTROLS
1. Pulse: The highest power mode will be activated for two seconds.
2. ON/OFF: Press the button to switch on the device, press again to switch it off.
3. Lo/Hi: Press the button to switch on low power mode, press it again to switch on high power mode.
Caution! If you want to choose from the pre-set programs, the speed control must be in the ON position.
If the speed control is in the ON position, the light indicators of the pre-set programs will flash slowly.
OPERATION
1. Place the food in the container and place the lid on the blender container (the recommended size of inserted food
is 2 x 2 x 2 cm). Gently press on the lid so it is sealed perfectly.
2. Place the container on the blender and turn clockwise. Before putting the appliance into operation, check that the
container is correctly seated in the base.
3. Connect the appliance to the electric mains and press the ON/OFF button.
4. Press Pulse or Lo/Hi see section Control Elements.
5. Remove the container from the motor base by turning the jar anticlockwise only if the motor is not running.
Note: The appliance is equipped with a safety fuse. It will not work without properly fitted jar. The appliance is
equipped with protection against overheating.
0
SM1500
EN
31
Publicité
