Publicité
Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety
information carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Package contents (Fig. A)
1 x hand towel holder, disassembled (1–5)
1 x installation materials (6–12)
1 x assembly instructions
Technical data
Dimensions: approx. 45 x 84 x 28cm (L x H x W)
Max. load per rail: 1kg
1
Date of manufacture (month/year):
05/2024
Intended use
The product is not intended for commercial use.
The product is designed for hanging towels,
clothing and bathrobes.
Safety Advice
Danger to life!
• Never allow children to play with packaging
materials or the product unsupervised. Suffo-
cation hazard!
Risk of injury!
• Ensure the product is properly stabilised
before using it.
• Place the product on a flat surface.
• The product may only be used under adult
supervision and must not be used as a toy.
10
GB/IE
• Check the product for damage and wear
before each use. The product may only be
used in good order and condition!
• Never stand, climb or sit on the product.
• The product must not be used as a ladder.
• Check whether the wall is suitable for mount-
ing the product. Unsuitable wall surfaces can
lead to injuries.
• Use the product only for its intended purpose.
Installation
To install the product you will need the enclosed
hex key (12), as well as the following tools (not
included in the package contents): a suitable
drill, a suitable screwdriver and a pencil.
Note: to facilitate assembly, do not tighten the
screws too much initially.
1. Place the individual parts (1–5) on a flat, soft
surface.
2. Assemble the product as shown in Figures B to E.
Note: make sure that you assemble the individual
parts correctly.
3. Tighten all screws.
4. Install the product on the wall, as shown in Fig. F.
Warning: to prevent it from tipping over, this
product should be attached to the wall with the
installation materials. Drill a hole in the wall and
attach the other end of the safety strap (8) to the
wall using the installation materials provided.
5. Glue the anti-slip pads (7) onto the bottom
corners of the product (Fig. D).
6. Observe the maximum load for the product.
Storage, cleaning
When not in use, always store the product
clean and dry at room temperature. Only clean
the product with a damp cloth and wipe dry
afterwards.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Publicité
