Publicité
Plug in the power cord. By using the control panel or the remote control :
IMPORTANT: Programmable remote control on several fans (not programmable on previous
versions). By default, the remote control only synchronizes with its fan, but it can be
synchronized to several fans. To do this, check that the batteries are installed in the remote
control, plug in the fan you want to take control of and within 10 seconds, press the Power
button on the remote control 4 times. At the 4th press, hold the button until you hear a beep
sound, indicating that the synchronization procedure was successful. Repeat the procedure
with all the fans you want to synchronize on the same remote.
Power ON / OFF
Press the Power ON/OFF button to turn the fan on/off.
Speed setting
Press the corresponding buttons to increase or decrease the speed. 6 speeds in total, speed
1 is the lowest speed and speed 6 is the highest speed. The corresponding indicators light
up on the control panel.
Press the Max speed button on the remote control to set the fan to maximum airflow (speed
6).
Timer
You can set the timer by pressing the Timer button so that it turns off automatically once the
selected time has been reached. Press the Timer button to set the timer, up to 9h max.
Each time the button is pressed, the timer increases by one level (1h, 2h, 3h, 5h, 7h, 9h).
The timer indicator lights up indicating that the function is activated.
To deactivate the timer, press the button until the indicator turns off or manually turn off the
fan.
Notes
A wall support for the remote control is provided (install it using screws and dowels adapted
to the structure of your wall), simply turn the remote 90° to unlock it and remove it from its
support. To replace it, turn again 90°.
To adjust the tilt, first turn off the fan and then loosen the angle adjustment knob. Adjust to
desired position and retain knob securely.
If you are not going to use your fan for a long time, we advise you to disconnect the
appliance from the AC power.
15
Publicité
