Declaration of conformity
EU and EFTA
Mounting the appliance
WARNING:
Do not mount the appliance on the ceiling; it is not designed for ceiling mounting.
For optional wall mounting, you need:
Screwdriver
Drill with appropriate size bit
For mounting on drywall:
Two #6 pan-head screws, 1 inch long (7mm diameter head, 25mm long)
Two wall anchors
For mounting on solid wood or metal:
Two #6 pan-head wood or machine screws, 1 inch long (7mm diameter head, 25mm long)
To mount the appliance on the wall:
1
Drill two holes 4.5 inches (11.5 cm) apart in the wall where you want to mount the appliance.
2
If using wall anchors, insert a wall anchor into each hole.
3
Insert a screw into each wall anchor (into each hole if not using wall anchors), leaving 3/16 inches (0.45
cm) of the screws exposed (including screw head).
4
Position the appliance mounting slots over the screws and press in and down until the appliance is
securely mounted.
Installing the appliance
WARNING:
For your safety, follow all instructions listed in this section.
Install in a location away from direct sunlight and sources of heat. A maximum ambient temperature of
104º F (40º C) is recommended.
Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios,
transmitters, and broadband amplifiers
The included power cord(s) are approved for use only in specific countries or regions. Before using a
power cord, verify that it is rated and approved for use in your location.
Ensure that no water or excessive moisture can enter the unit.
Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of
1 inch (25.44mm) clearance is recommended.
SonicWall TZ400 W
Safety and Regulatory Information
2