Publicité
GB
Safety instructions
• The light may be installed indoors only.
• To operate this product safely, the user must have
read and understood these instructions for use
before using the product for the first time.
• The device must only be used when it functions
properly. If the product or part of the product is
defective, it must be taken out of operation and
disposed of correctly.
• Always keep the operating instructions within
reach.
• If you sell or pass on the device, you must also
pass on these operating instructions.
• When working on walls, ceiling or floors, pay
attention to any installed cables as well as gas
and water lines.
• Only use connection cables permitted by the
manufacturer.
• Do not touch the mains plug with wet hands!
Always pull out the mains plug at the plug and not
by the cable.
• Do not bend, crush, pull or drive over the power
cable, protect from sharp edges, oil and heat.
• If the power cable is damaged immediately dis-
connect the plug. Never use the device if the
power cable is damaged.
• Mains voltage and fuse protection must comply
with the technical data.
• The fuse must be a residual current circuit-
breaker with a measured residual current of no
more than 30 mA.
• The light source of this luminaire is not replacea-
ble; when the light source reaches its end of life
the whole luminaire shall be replaced.
• This product contains a light source of energy effi-
ciency class <F>.
Risk of damage to the eyes! Never look di-
rectly into the LED.
The light can only be used in dry indoor areas.
Light source non-replaceable
Control gear non-replaceable
230 V
230 V
Fault/malfunction
The lamp does not light up
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
10
Installation
LED underfit lamp
Cleaning
– Wipe down the device with a dry or damp cloth.
Storage and transport
Storing
– Store the device and any accessories in a dry,
– In case of longer periods without operation, pro-
Transport
– Use the original packaging to ship whenever pos-
Troubleshooting
If something stops working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
No mains voltage?
Light source defective?
Luminaire switched on via switch?
Switch defective?
Connection cable defective?
Incorrect connection?
Note: The actual appearance of your prod-
uct may differ from the illustrations.
Note: With the enclosed connector/connect-
ing cable, up to 10 lights of the same type
may be switched in series.
NOTICE! Risk of damage to the device!
Do not use any sharp or abrasive objects, or
aggressive cleaning agents.
Do not use cleaning solutions.
well-ventilated place.
tect the device and its accessories against soiling
and corrosion.
sible.
DANGER! Danger to life and limb!
Improper repairs can result in the product
functioning unsafely. This endangers your-
self and your environment.
DANGER! Risk of fatal injury due to elec-
tric shock! All work to eliminate possible
faults should be carried out with the fuse
switched off. All work should be carried out
by a qualified electrician.
Remedy
Check fuse. Contact a specialist.
Check illuminant, replace if neces-
sary if possible
Check switch position
Contact a specialist.
Contact a specialist.
Switch off the fuse and check the
connection according to the wiring
diagram. Contact a specialist.
Publicité
