Publicité
GB
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
Remaining risks
There will still be residual risks even when the device
is used according to the instructions and under obser-
vation of all of the safety notes in this set of operating
instructions:
• Touching the tool in the uncovered section.
• Reaching into the operating tool.
• Kickback from work pieces and work piece parts.
Personal protective clothing
Wear goggles when working with the device.
When working with tools that cause consid-
erable dust, wear a dust protection mask.
If you have long hair, cover or wear a hair
net.
Do not wear protective gloves when working
with the device.
Your device at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, fig. 1
1. Locking button
2. Revolution regulator
3. On/Off switch
4. Bending shaft
5. Handle
6. Tool holder
Scope of delivery
• Operating manual
• Axial grinder
• Case
• Bending shaft
• Installation wrench
• Tool stand
• Additional handle
• Depth stop
• Collet chucks (various diameters)
• Coupling nut
• Locking pin for the bending shaft
• Various sanding/grinding bodies
• Polishing and cutting discs
• Drill
• Sanding/grinding bits
34
Operation
Check before switching on!
Check to make sure the unit is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all unit components are cor-
rectly mounted.
Inserting a tool
► P. 3, fig. 2
CAUTION! Risk of injury! Only use tools
approved by the manufacturer!
Never use damaged tools. Always check
tools for tears and other damage before
mounting.
Only use tools that are appropriate for the
material you are processing.
Only use tools with a permitted revolution
that is at least as high as the idle revolutions
of the unit.
1. Fit the appropriate collect chuck for the tool into
the tool holder.
2. Screw the coupling nut into place.
3. Fit the required tool into the collet chuck.
4. Press and hold down the locking button.
5. Tighten the coupling nut with the supplied mount-
ing wrench.
Using the bending shaft
NOTICE! Risk of damage to the unit! Do
not fold the bending shaft or bend too tightly
(► P. 4, fig. 4).
► P. 4, fig. 3
1. Fit a collet chuck with ø2 mm in the tool holder.
2. Screw the coupling nut into place.
3. Fit the shaft of the bending shaft into the collet
chuck.
4. Press and hold down the locking button.
5. Tighten the coupling nut with the supplied mount-
ing wrench.
6. Place the coupling nut of bending shaft onto the
device.
7. Tighten the coupling nut.
Inserting a tool
1. Fit the appropriate collect chuck for the tool into
the tool holder.
2. Screw the coupling nut into place.
3. Fit the required tool into the collet chuck.
4. Fix the bending shaft with the locking pin.
5. Tighten the coupling nut with the supplied mount-
ing wrench and remove the locking pin.
Attaching the additional handle
► P. 5, fig. 5
– Push the additional handle (7) over the tool
holder.
– Tighten the coupling nut (8).
Publicité
