Publicité
GB
Wear tight fitting clothes when working with
the device.
If you have long hair, cover or wear a hair net.
Assembly
Scope of delivery
Note: The actual appearance of your prod-
uct may differ from the illustrations.
• Base plate
• Column
• Lever
• Protective cover for the drill
• Fixing screws and nuts
• Allen wrench
• Operating manual
Note: If any one of the parts is missing or
damaged, contact the retailer.
– Assemble the unit as shown (► P. 2, fig. 1).
– Use the appropriate screws to screw the drill
stand firmly to the work bench (► P. 3, fig. 2).
– Insert the drill into the accommodation element on
the unit and screw firmly to secure.
– Feed the cable of the drill through the cable holder
(► P. 3, fig. 2).
Operation
DANGER! Risk of injury! Before using the
unit, the user must have read and under-
stood the operating instructions for the drill.
Drilling
– Secure the work piece in the vice (not included as
part of the scope of delivery).
– Position the vice, and use suitable screws to fas-
ten it firmly to the base plate.
– Switch on the drill and use the lever to carefully
lower the machine head.
Setting the depth stop
► P. 4, fig. 3
– Lower the machine head until the tip of the drill
touches the work piece.
– Loosen the screw (1) to allow the guide rail (2) to
drop freely.
– Push the work piece to the side.
– Lower the machine head to the required drill
depth and hold in place.
– Read the drilling depth off the scale (3).
– Tighten the screw (1).
Setting the play of the guide rail
► P. 4, fig. 4
– Adjust the setting screw (4).
12
Maintenance
► P. 4, fig. 5
– Clean and oil the guide rail (2) and column (5)
regularly as shown.
Disposal
Disposal of the appliance
This appliance must not be disposed of with regular
household waste! Dispose of the appliance in the
appropriate manner. For more information, consult
your community waste disposal service.
Disposal of the packaging
The packaging consists of cardboard and
correspondingly marked plastics that can
be recycled.
– Make these materials available for recy-
cling.
Technical data
Part number
Working radius
Working lift
Column height
Column diameter
Clamp
Base plate
116105
110 mm
60 mm
500 mm
ø 25 mm
ø 43 mm
230 × 160 mm
Publicité
