in-akustik Exzellenz HDMI Mode D'emploi page 12

OPER ATION MANUAL E X ZELLENZ HDMI WIRELESS
C. IR EXTENDING FUNCTION
1. Make sure the IR emitter Probe have been installed properly on the Transmitter Box.
2. Make sure the IR receiver Probe have been installed properly on the Receiver Box.
3. Use the remote controller of your source device to control the source form the Receiver Box.
Note: Please do not cover both Transmitter and Receiver with any object. Because those object could block the
air circulation.
TROUBLE SHOOTING
1. When there is no picture presented, please:
• Make sure the direct connection from source device to sink device can work properly.
• Check if all connectors are connected well; check if all cables can support the transmission speed. High
Speed HDMI cables are recommended.
• Unplug the power cable to restart the Excellence wireless HDMI kit.
2. When there is no sound:
• Please try to adjust the volume of TV.
• Check cable connection to see if it fits properly.
• Check cable to see if it supports video transmission only (DVI) or it is damaged already.
• HDCP may not match very well at first connection; please unplug the power cable to restart the Excellence
wireless HDMI kit.
3. When there is no 3D effect, please:
• Make sure 3D function of 3D TV (or 3D DLP Projector) is activated (set to AUTO or 3D ON).
• Make sure 3D function of 3D source device is activated (set to AUTO or 3D ON).
• Make sure power of shutter glasses is on.
• Check the power of the Excellence wireless HDMI kit.
• If the 3D HDTV requires an active shutter glasses for 3D viewing, please make sure the active shutter
12