Publicité
Informations CEM et déclaration du fabricant
Electromagnetic Compatibility Information
1. This device needs to be installed and put into service in accordance with the information
provided in the user manual.
2. WARNING: Portable RF communications equipment (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches) to any part of
the AC1000f, including cables specified by the manufacturer. Otherwise, degradation of the
performance of this device could result.
If higher IMMUNITY TEST LEVELS than those specified in Table 9 are used, the minimum
separation distance may be lowered. Lower minimum separation distances shall be calculated
using the equation specified in 8.10.
Manufacturer's declaration-electromagnetic immunity
The AC1000f is intended for use in the electromagnetic environment specified below. The
customer or the user of the AC1000f should assure that is used in such and environment.
Immunity test IEC 60601 test level
3 Vrms:
0,15 MHz – 80 MHz
6 Vrms: in ISM and
Conducted RF
amateur radio bands
IEC 61000-4-6
between
0,15 MHz and 80 MHz
80 % AM at 1 kHz
10 V/m
Radiated RF
80 MHz – 2,7 GHz
IEC 61000-4-3
80 % AM at 1 kHz
NOTE1: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE2: These guidelines may not apply in all situations. Electromagnetic propagation is af-
fected by absorption and reflection from structures, objects and people.
More information on EMC compliance of the device can be obtained from Rossmax website:
www.rossmax.com
30
Compliance level
Electromagnetic environment-
Portable and mobile RF com-
munications equipment should
be used no closer to any part of
3 Vrms:
the AC1000f including cables,
0,15 MHz – 80 MHz
than the recommended sepa-
6 Vrms: in ISM and
ration distance calculated from
amateur radio bands
the equation applicable to the
between
frequency of the transmitter.
0,15 MHz and 80 MHz
Recommended separation dis-
tance:
80 % AM at 1 kHz
d = 1,2 √P, d = 1,2 √P 80MHz to
800 MHz, d = 2,3 √P 800MHz to
2,7 GHz
Where P is the maximum output
power rating of the transmitter
in watts (W) according to the
transmitter manufacturer and d
10 V/m
is the recommended separation
80 MHz – 2,7 GHz
distance in metres (m).
80 % AM at 1 kHz
Interference may occur in the
vicinity of equipment marked
with the following symbol:
guidance
Publicité
