Publicité
Safety
These instructions are for your safety. Please read through
them thoroughly prior to installation and retain them for future
reference.
accordance with local regulations (IET wiring regulation
BS7671).
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap etc from the product.
Decide on the appropriate location for your product.
Always avoid the product to be located at corrosive environment.
Always refer to the installation drawing for the orientation of the
product.
It is always recommended to cut the hole slightly smaller than
Wiring diagram is for reference only. Always refer to the terminal
marking for wiring. Ensure that all electrical connections are tight
and that no loose strands are left out of the terminal block.
When the product does not light after installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
If you have any doubt about installation/use of this product,
Always disconnect the product from mains at least 10 minutes
allowing to cool down before any maintenance or adjustment.
It is recommended to have a regular schedule of care and
maintenance to keep the surface condition well.
Warranty Period and Conditions
At Blooma, we devote special attention to selecting high-quality materials and use manufacturing techniques that enable us to create
designer and durable product ranges.
That is why we offer a 5-year warranty against product manufacturing defects for the LED component in this product. The guarantee terms
and conditions are available in store.
This product is under warranty for 5 years as from the date of purchase, for normal, non-professional household use for the LED component
in this product. The warranty shall only apply upon presentation of the till receipt or the invoice. Keep your proof of purchase in a safe place.
The warranty covers product breakdowns and malfunctions under the condition that the product is used in accordance with its intended use
and subject to installation and maintenance in accordance with good practice and the information contained in the user's manual.
This product must be installed so that it may be later removed without damaging it.
This contractual warranty does not cover defects and damage caused by the natural wear of parts, bad weather
freezing, damage caused by water quality (hardness, aggressiveness, corrosion, etc.), by the presence of foreign bodies transported by
negligence, accident or maintenance that is defective or does not comply with good practice or the information in the user's manual.
The following are also excluded from the warranty: harmful consequences due to the use of accessories and/or non-original equipment
The warranty is limited to those parts recognised as defective. Under no circumstances shall it cover fringe expenses (travel, labour) and
direct and consequential damage.
This guarantee is in addition to and does not affect your statutory rights.
3663602893189-Blooma-A5-IM-V03. indb 3
Technical Data
Supply Voltage:
220-240 V~, 50 Hz
LED (4.3 W), The light source of this luminaire
is not replaceable; when the light source
Bulb Type:
reaches its end of life the whole luminaire
shall be replaced. Do not stare at the
operating light source.
Model: YKDG05CC160V1
Transformer:
Input: 220-240 V~, 50 Hz, 5,5 W
Output: 27 V DC , 160 mA , 4.3 W
Conformity with all relevant EC Directive
requirements.
Class II product - Double Insulated - No earth
required.
Class III product - designed to be supplied
from a SELV (Separated or Safety Extra-Low
Voltage) power source.
IP20
IP65
Jet-proof
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or local store for recycling
advice.
Luminaires not suitable for covering with
thermally insulating material.
This product is not suitable for dimming.
xxWyy
xx-year; yy-week of the year
7/8/2019 16:18
Publicité
