Publicité
• Remove the steam basket: Place the measuring cup in the slot of the steam basket and
twist to secure. Then extract it.
MISTAKE
E01
E02
E03
E05
E06
E07
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous
substances in electric and electronic equipment as well as their waste disposal. The symbol with the
crossed dustbin shown on the package indicates that the product at the end of its service life shall be
collected as separate waste. Therefore, any products that have reached the end of their useful life must
be given to waste disposal centres specialising in separate collection of waste electrical and electronic
equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one
basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible nega-
tive effects on the environment and health and optimises the recycling and reuse of components making
up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.
ERROR MESSAGES
CAUSE
Engine overload.
No weighing sensor was detect-
ed or the weighing sensor was
damaged.
The robot jar is not attached or the
NTC is damaged.
Dry burning water during steam
function.
No NTC detected.
Engine heat dissipation barrier.
SOLUTION
• Unplug and let the device cool for
one hour.
• Then it will be ready for use again.
• Contact after-sales service.
• Place the jug in its place.
• Clean the lower bowl pin.
• Turn off the robot and add water to
the container.
• Turn it on after the temperature inside
the jar cools down.
• Clean the lower bowl pin.
• If the error persists, contact af-
ter-sales service.
• Contact after-sales service.
E NGLI SH
15
Publicité
