Publicité
EN
GETTING STARTED
The 3D S tation® products work with A/C power adapter for the base and with Batteries AAA for the outdoor probe .
BATTERIES
Before the first use, remove the plastic insulator at the back side product to activate the battery pack.
To open the batteries compartment :
1. Bring up the battery door on the weather station's back.
2. Insert the 2 Alkaline batteries AAA in the batteries pack of the outdoor Probe.
3. Close again batteries compartment.
NOTE Do not use rechargeable batteries. We advise you the use of Long Lasting Alkaline batteries AAA. The batteries
power electrical cut and not for a long life product
use. If you notice a continuous unstable display, please change the batteries and plug the product on AC
adapter.
A/C POWER ADAPTER
The power adapter plug is located under the base of the weather station.
To connect the power adapter :
1. Lift the weather station vertically from top.
2. Make sure to insert correctly the plug until the end of the port so that it does not exceed.
3.Connect the power adapter plug in the DC port.
4. Put back the Weather Station.
5. Connect the other extremity of the power adapter in a mural catch (220 Volts).
- 25 -
Publicité
