Publicité
1 Setting up the VoIP communication
Define the duration of the ring tone in the tile settings of the Door intercom widget
■
The widget closes automatically 3 seconds after the door is opened.
■
Video transmission in MJPEG, JPEG and RTSP
■
1.2 Option 2: Setting up the YOUVI camera module
To make use of the TCS AVE door station's camera, it needs to be added and set up within
YOUVI Configuration.
1.
To add the camera module open YOUVI Dashboard on the panel and select Install Camera
Device. If you do not have a full license yet, you can purchase it in the PEAKnx Shop.
2.
Switch to YOUVI Dashboard > Camera Device OR open the configuration page at a PC in
your browser, making sure that the system running the browser is on the same network as
the PEAKnx Touch Panel. To do this, enter the following URL in your browser:
−
http://x.x.x.x:31228
−
Where x.x.x.x must be replaced by the local IP address of your PEAKnx touch panel. This
can be found in the Fritzbox settings (fritz.box) under Home network and the respective
device.
3.
From the menu on the left, select "Cameras".
4.
Use the „+" symbol to add a new camera set.
5.
Click the "+"-Symbol next to "Select Camera Stream" to create a new camera stream.
6.
For the "Stream Name", enter an appropriate name of your preference for your TCS AVE
door station, e.g. "TCS door station"
7.
Change the "Stream Type" to "MJPEG".
8.
For both the "Low Resolution URL" and the "High Resolution URL" enter a URL of the follo-
wing signature:
−
http://x.x.x.x:12000/video.mjpg
−
Where x.x.x.x is the IP address of your TCS AVE door station. These can be found for
example in the Fritzbox settings (fritz.box) under Home network and the respective device.
−
"12000"
is the video port. It can also be customized in the TCS configuration in the menu
item Settings > Video.
16
Publicité
