Publicité
INSTALLATION GUIDE
1
Place the Door Drilling Template
2
Drill the holes on the door
on the door.
according to the Door Drilling
Template.
Use a pin driver to mark the
point where you need to drill.
If there is an existing mortise
lock, remove it before drilling.
7
Install inner handle set on the
8
Put the cover plate on the inner
door, and screw the outer
handle set.
handle set and inner handle set
tightly.
3
Install the spindle on the outer
4
Screw two xing poles on the
handle set and use hexagon
outer handle set.
driver (#1.5) to tighten the spindle.
The screw hole of the spindle
must be at the bottom and the
mark of the coupling must be on
the top.
9
Turn the screw at the bottom of
10
Install the inner handle and use
the inner handle set anti-clock-
hexagon driver (#3.0) to tighten
wise (go outside) until you feel
the screw on both inner and
resistance.
outer handle.
5
Install outer handle set on the
6
Take away the handle of the
door.
inner handle set and turn the
screw at the bottom of inner
handle set clockwise (go inside)
until the cover plate can be
pulled out.
11
Use hexagon driver (#1.5) to turn
12
Install CR2 lithium battery and
the screw at the bottom of outer
install the battery holder back to
handle set anti-clockwise then
the outer handle set.
pull out the battery holder.
Publicité
