Publicité
it is recommended to
clean the inside of your
mouth with water after
brushing your teeth.
04 Do not run the main
unit on empty except
to empty the remaining
water after use. Using
the main device
without water may
cause a malfunction.
05 if the tip of the cannula is
deformed, replace it with
a new one recommended
by lAnAFORM.
7. Cleaning and
maintenance
Cleaning the main
unit :
• Only clean the device with
clean water or a neutral de-
tergent. Do not use corrosive or
abrasive detergents. Do not use
water above 50°C on any part of
the device as this could cause
damage or loss of performance.
• Do not immerse the main unit
in water. if necessary, clean the
surface with a soft cloth and
non-corrosive detergent.
Tank cleaning :
• Detach the tank from the main
unit, as explained in point 6.
• Rinse the tank with lukewarm
water. Do not clean the reser-
voir with detergent of any kind.
• R e p l a c e t h e t a n k a ft e r
cleaning.
Limescale cleaning :
• Depending on the mineral
content of the water used, a
limescale deposit may appear
on the device. This may reduce
the performance of the device.
• Point the tip towards the sink,
8
turn on the device and leave it on
until there is no water in the tank.
Replace the tank with clean hot
water (maximum 40°C) and re-
peat the above-mentioned tank
cleaning steps. This cleaning pro-
cess should be repeated every
1-3 months in order to maintain
product performance.
8. Changing the tip
• The tip is a consumable. The
tip should be replaced approxi-
mately every 6 months for hygie-
ne reasons, even if its shape re-
mains unchanged.
8
Publicité
