Publicité
IMPORTANT WARNING FOR THE USE AND MAINTENANCE OF THE LAMP
1. When first lighting the lamp, or if the appliance has been shaken, there is a possibility that gas
comes out: this fact must not create panic because its length is very short.
2. Do not modify the appliance:
- The manufacturer does not accept any responsability for problems arising due to.
- Incorrect usage of the appliance.
- Carelessness during usage of the appliance.
3. Alterations and modifications of the appliance.
4. Fitment of wrong components (gas cartridge, washer, gas mantle).
5. The appliance works with 190 g butane gas cartridge only.
6. Before inserting the gas cartridge, read carefully the instructions pinted on the gas cartridge.
7. Always use this appliance outside. Removing and the fitting of the gas cartridge should be done
outside.
8. The butane gas is dangerous and treat it carefully.
9. Ensure the appliance is kept out of reach of children.
10. Do not use the appliance if the washer is in bad conditions.
11. Do not use the appliance if there is any gas leaks, if it is damaged or it is not working correctly.
12. In the case of gas leaks, place the appliance outside away from flames and other inflamable sourc-
es or materials. Find the gas leak outside, use soapy water and never a naked flame.
13. The support surface of the appliance must be horizontal.
14. The appliance must not be used near inflammable materials.
15. Ensure the knob of the gas valve is fully closed before inserting the gas cartridge or replacing the
gas cartridge.
CLEANING OF THE APPLIANCE
Before storing the appliance ensure the gas valve is fully closed and the appliance is cleaned carefully.
This cleaning is particulary recommended if the appliance is not to be used for a long period.
INSTRUCTIONS FOR USE
A) INSTALLATION OR CHANGE OF CARTRIDGE
1. Close carefully the brass gas valve of the appliance.
2. Ensure that the pin washer is in perfect condictions.
3. Ensure the gas cartridge to be replaced is completely empty before inserting a new one. Never
change a cartridge unless the appliance is shut off.
4. Twist off the bottom of the cartridge holder. Insert the gas cartridge and twist onto the bottom of
the cartridge holder.
B) LIGHTING OF THE LAMP
1. Remove the packing from the glass cylinder.
2. Remove the handle and the glass cylinder.
3. Verify that the gas mantle is inserted in the right position, in case of absence of the mantle insert
it in the cylindrical mantle holder and be sure that the two ends of the mantle are located in the
two spline of the mantle holder.
4. Light a match and put it near the mantle, open slowly the gas valve until the gas ignites. If the ppli-
ance is provided with piezo ignition, press the black button after the openning of the gas valve.
5. Re assemble the glass cylinder and the handle.
6. To regulate the intensity of the light, slightly open or close the knob of the gas valve.
C) SHUTDOWN OF THE LAMP
To shutdown the lamp, the control knob of the gas valve must be fully closed.
4
Publicité
